Phone:  Toll Free: 800-240-1310 or Local: 770-808-0023Contact Us Site Map Home

 

Bumper Weld - #BW5

Item # BW5 - Rapid Set - Non-Sag - High Modulus

 

Rapid set, use with meter mix pumping equipment, or is packaged in easy-to-use two component cartridges.  BUMPER WELD is a two component, 100% solids, non-abrasive, high modulus epoxy gel. It is used to adhere parking bumpers to concrete and other like substrates. BUMPER WELD is supplied in easy-to-mix 1:1 by volume ratio and is color-coded to assure that mixing is complete.

 

Uses

  • Adhere pre-cast concrete parking bumpers.
  • Bonding hardened concrete and other materials to hardened concrete.

Advantages

 
  • Moisture insensitive - may be applied to dry or damp concrete or in humid conditions.
  • Color-coded for error-free mixing.
  • 100% solids, conforms to VOC regulations. No mechanical anchors or fasteners required.
  • Superior sheer strength to concrete and asphalt.

Surface Preparation

All concrete surfaces to be bonded should be dry for best results. However, a damp surface dry condition is acceptable. Surfaces must be free of standing water. The substrate must be clean and free of oil, grease, coatings and any other contamination.

 

Mixing & Application

Mix thoroughly, 1 part of Component A with 1 part of Component B by volume. Product should be a homogeneous gray with no black or white streaks

 

Limitations

  • Do NOT allow the product to freeze.
  • Do NOT apply when temperature is below 50oF.
  • Do NOT apply to latex modified mortar or concrete.

Clean Up

Clean tools and equipment immediately with a suitable solvent such as xylene or lacquer thinner.

 

Caution

For professional use only. Epoxy systems can cause delayed dermatitis. Avoid prolonged contact with skin. See Material Safety Data Sheet for proper handling and required safety equipment.

 

Specification

  • Packaging: 2 component cartridges, 2 gallon units, 10 gallon units, 100 gallon units
  • Pot Life (100 Grams): 5-10 minutes
  • Compressive Strength: > 10,000 psi (ASTM D-695)
  • Tensile Strength: > 8,000 psi (ASTM D-638)

     

2527 Lantrac Court

Decatur Georgia GA 30035
Info@SuperiorEpoxies.com

Toll Free

Phone: 800-240-1310    Fax: 800-240-7662

Local

Phone: 770-808-0023    Fax: 770-808-6777

Copyright © 2015 - Superior Epoxies, Inc.